- Minimum Order Quantity :
- Unit of Measure :
Cross Hatch Cutter Kit
The cross hatch cutter Will allow an assessment to be made of the adhesion resistance of coatings to separation from substrates When a right-angled lattice pattern is cut into the coating and penetrates through to the substrate. The coating thickness determines the cutter size used. The 1mm cutter is suitable for coatings under 60 microns; the 2mm cutter is suitable for coatings over 60 microns.
Simple operation, each cross hatch cutter has 6 / 11 cutting blades spaced either 1mm or 2mm apart, one cutting pass makes 6 cuts in the coating, a second pass at 90Â° makes a square lattice pattern. Apply adhesive tape over cut section and Within 5 minutes remove tape. Classify the cut area according to the relevant national standard classification guide.
The cutting blades are ground onto 6 cutting sides, so that when one cutting side becomes blunt there are a further 5 cutting sides to use. Therefore giving a 1/3 rd extra life over conventional 4 sided models.
This cross hatch cutter complies With ISO, BS, DIN and ASTM methods of measurement. Complete kit is supplied in a carrying case
Cross Hatch Cutter
1mm cutters for coatings under 60 micron With 6 teeth
2mm cutters for coatings over 60 micron With 6 teeth
1mm cutters for coatings under 60 micron With 11 teeth
Adhesion Tape complies With ISO2409
Viewing Lens complies With 1802409
D/104, Twin Arcade, Military Road, Marol, Andheri (E), Mumbai, Maharashtra, 400059, India